TV To FM Converter Using Single Transistor

Comment errors or corrections found for this circuit, and get the chance to win big!

Here is a simple circuit of TV to FM converter. With this simple one transistor BF 494 circuit you will be able to receive FM and VHF stations on your old Black And White TV sets.

The circuit uses only one NPN transistor T1,  BF 494 and few other components. A + 6V power supply for this circuit could be taken from a TV set or use a 9V battery separately.

Fig.: BF494 Pin
Fig.: TV to FM Converter Prototype

Circuit Description

A transistor BF494 and together with a resistors R1, R2 will biased a transistor and capacitors C1 is connected  base of T1 and +9V.C2 is connecte to a base and emitter. And will make a oscillator circuit which oscillates a frequency between 93.5 MHz-113.5 MHz. Transistor T1 will also works as a mixer which will mixed with frequecies between  88.00MHz -108.00 MHz and will give an output SIF signal between 5.5MHz, which is passed to an 5.5MHz IF input of your TV set.

Fig.: Circuit Diagram

Inductor L* is connected on parallel with VC1 (2-22pF trimmer) and to a + 6 Volts power supply and a collector terminal of Transistor BF 494. An antenna of 75cm long with wire is connected to an emitter of BF 494 through a capacitor C4 (.001uF). This antenna will boost a low signal. Capacitor C1 is connected between a base of BF 494 and to a +Vcc.

Capacitor C2 (10pF) is connected to a collector and an emitter of BF 494 and this capacitor will give a feedback signal to oscillates a circuit. Capacitor C5 is connected between +9V supply and ground will filter a DC power supply.

An output signal 5.5MHz is taken away from a emitter of BF 494 and a capacitor C3 33pF and connected to an input of SIF section of TV through a switch to “ON” switch.

Construction and Calibration

You will need an inductor L* which can be wound of 5 turns on a 6mm aire core of 23 SWG wire.  A suitable vero board of size 5cm*7cm can be use to make your FM radio receiver.A trimmer capacitor VC1 is used for tuning different stations. Connect a 9 Volts battery to a circuit and connect an output terminal to SIF section TV set. Now turn ‘ON’ a TV set. You will hear hissing sound from your TV.Now slowly adjust a VC1 or adjust a coil L* by pulling them toward or apart until you’ll hear a nearby FM stations. You may also use an antenna of 75cm long wire to make an antenna if you are receiving a poor signal.*

Fig.: PCB and Component Layout

Parts List

Semiconductor

T1: BF 494

Resistors

R1: 470K

R2: 470

Capacitors

C1: .01uF

C2: 10pF

C3:33pF

C4:.001uF

C5:.01uF

VC1: 2-22pF trimmer capacitor

Coil L*: 5 turns of 23 SWG wire on 5mm air core, wires, 2-pin connectors, 9 V battery, switch to ‘ON’ switch e.t.c.


Source link

This site uses cookies to offer you a better browsing experience. By browsing this website, you agree to our use of cookies.